G-Tools Bonanza 0.35m² XL Height Extension Set
Adds 56cm of headroom to your Bonanza 0.35m² cabinet, bringing total height to 232cm.
Key Features
- Adds 560mm of height to the Bonanza 0.35m² cabinet
- Total cabinet height becomes 2,320mm after fitting
- Includes a full replacement back panel
- Back panel pre-drilled with air intake holes
- Air outlet and cable entry holes located in the new XL back panel
- Compatible with G-Tools 3-in-1 irrigation system use cases
- Suitable for HPS and LED light sources requiring greater canopy distance
- Can be installed at any point during the grow cycle
- Designed exclusively for the G-Tools Bonanza 0.35m² cabinet
The G-Tools Bonanza XL Height Extension Set gives your 0.35m² Bonanza cabinet an extra 560mm of vertical space. It suits growers who've run out of headroom mid-cycle or who want to run taller plants, irrigation systems, or high-hung lighting from the start.
Plants grow faster than expected. It's one of the most common problems in a sealed cabinet. A vigorous indica can close the gap between canopy and light within days. With this extension set fitted, you have 232cm of total height to work with. That margin makes a genuine difference when managing stretch during early flower.
HPS users benefit most from extra headroom. HPS bulbs generate significant heat and must be kept well clear of the canopy. LED fixtures are more forgiving but still need adequate distance for uniform coverage. Adding 56cm means you can hang either light type at the correct height without compressing the grow space below.
If you plan to use G-Tools' 3-in-1 irrigation system, this extension set is worth fitting from the outset. The irrigation assembly occupies vertical space inside the cabinet. The XL set offsets that loss so your plants still have room to develop. It's far easier to install the extension before your first run than to retrofit it around an established crop.
Installation is straightforward. Remove the cabinet roof, connect the new back panel, and attach the upper extension panels. The new back panel arrives with air intake holes already cut. The air outlet and cable entry points are also positioned correctly on this panel, so ventilation routing stays clean and logical. No specialist tools are required.
Grower’s Note: When you extend cabinet height, reassess your extraction rate. A taller internal volume needs slightly more airflow to maintain the same air-change frequency. If your fan is already running at full speed, consider stepping up to the next fan size or adding a second passive intake lower on the cabinet to improve throughput. Also recheck your VPD targets - a taller canopy-to-light distance can affect leaf temperature and transpiration rates at canopy level.
Priced at £269, with free UK delivery.
- Adds 560mm of height to the Bonanza 0.35m² cabinet
- Total cabinet height becomes 2,320mm after fitting
- Includes a full replacement back panel
- Back panel pre-drilled with air intake holes
- Air outlet and cable entry holes located in the new XL back panel
- Compatible with G-Tools 3-in-1 irrigation system use cases
- Suitable for HPS and LED light sources requiring greater canopy distance
- Can be installed at any point during the grow cycle
- Designed exclusively for the G-Tools Bonanza 0.35m² cabinet
Dimensions
C: Height
56cm extension (232cm total)