G-Tools Grow Table for Ebb & Flow Tray 1.1 x 0.63 m with Mounting Bracket

The G-Tools Grow Table gives you a clean, dedicated base for ebb & flow cultivation without unnecessary complexity. It suits growers who want a tidy, scalable setup that keeps irrigation, lighting, and canopy management in one organised unit.

At 1.1 m wide and 0.63 m deep, this table pairs directly with the matching G-Tools ebb & flow tray. The aluminium frame resists moisture and nutrient splash, which matters in any flood-and-drain environment. You won't be fighting rust or warped supports after a few growing cycles.

The overhead tube bar is genuinely useful. Hang your LED fixture directly above the canopy, clip on oscillating fans to improve air movement, or run a SCROG net at the right height from the outset. Everything stays centred over the tray with no additional rigging required.

Underneath the table there is enough clearance to sit a nutrient reservoir directly below the tray drain. This keeps your growing area compact and your pipework short. Shorter pipe runs mean fewer leak points and easier priming of your flood pump.

The table works as a standalone unit for a single-tray grow, or you can integrate it alongside other G-Tools tables to fill a larger growing space. Adding the optional castor wheels lets you roll the whole assembly out for maintenance, which is a small convenience that saves real time over a long grow.

Grower’s Note: With ebb & flow systems, table height relative to your reservoir matters. The pump must be able to flood the tray fully within a few minutes, so keep your reservoir positioned close to the drain point and check that the pump's head pressure matches the vertical lift required. A short flood cycle of around 15 to 20 minutes, followed by complete drainage, is typical for most growing media.

Priced at £205, with free UK delivery.