Sanlight EVO Angled Extension Lead 1m

This 1m angled extension lead is the proper connection cable for building a daisy-chain array of Sanlight EVO grow lights. It suits growers running two or more EVO panels who want a clean, manufacturer-approved link between fixtures.

Running multiple Sanlight EVO panels across a wide canopy means managing several power and signal connections. This lead solves that neatly. Rather than running individual cables back to a wall socket or timer, you link each EVO unit to the next in line, then power the whole chain from a single point using the Sanlight distribution block.

The angled connector is a practical detail. On a suspended LED bar, a straight plug can protrude awkwardly and create slack loops. The angled design keeps the plug flush against the fixture, reducing the risk of snagging on training nets or plant growth below. In a packed 1.2 x 1.2m or 1.5 x 1.5m tent this matters more than it sounds.

At 1m, the lead gives enough slack to span the gap between two EVO panels mounted side by side without pulling tight. If your array is wider or your fixtures are spaced further apart, Sanlight also produce longer leads - check the full accessory range before ordering. For most two- or three-panel setups in standard UK tent sizes, 1m is the right choice.

This lead is a small but essential purchase when you expand beyond a single EVO fixture. Order one lead per additional panel you plan to run. Pair it with the Sanlight distribution block if you have not already - the block is the central hub that the whole chain feeds back to.

Grower’s Note: When daisy-chaining LED fixtures, keep the total load within the rated capacity of your distribution block and never exceed the manufacturer's maximum chain length. Check that your circuit can handle the combined wattage of all linked panels before powering up.

Priced at £45, with free UK delivery.